BEA WebLogic Server 7 Manuel d'utilisateur télécharger pdf (Page 5)

Configuring the BIG-IP LTM for WebLogic Server

To configure the BIG-IP LTM system for WebLogic Server, you need to

complete the following tasks:

• Creating the health monitor

• Creating the pool

• Using SSL certificates and keys

• Creating profiles

• Creating the virtual server

• Modifying the WebLogic configuration

After finishing this section, the following section, Configuring the BIG-IP

LTM system for WebLogic Portal, on page 17, contains procedures for

configuring the BIG-IP LTM for WebLogic Portal Server.

Creating the health monitor

The first step is to set up a health monitor for the WebLogic Servers. This

procedure is optional, but very strongly recommended. In our example, we

create a simple HTTP health monitor. Although the monitor in the following

example is quite simple, you can configure optional settings such as Send

and Receive Strings to make the monitor much more specific.

To configure a health monitor

1. On the Main tab, expand Local Traffic, and then click Monitors.

2. Click the Create button. The New Monitor screen opens.

3. In the Name box, type a name for the Monitor.

In our example, we type wls-http.

4. From the Type list, select HTTP.

5. In the Configuration section, in the Interval and Timeout boxes,

type an Interval and Timeout. We recommend at least a 1:3 +1 ratio

between the interval and the timeout. In our example, we use a

Interval of 30 and a Timeout of 91.

6. In the Send String and Receive String sections, you can add a Send

String and Receive Rule specific to the device being checked.

7. Click the Finished button.

The new monitor is added to the Monitor list (see Figure 2).

1 2 3 4 5 6 7 8 9 10 ... 27 28

Pas de commentaire

BEA WebLogic Server 7 Manuel d'utilisateur Page 5